Welcome to the OZPWC.COM Message Boards.

Search:

Type: Posts; User: benny579; Keyword(s):

Search: Search took 0.01 seconds.

  1. Disregard I found it straight after I posted....

    Disregard I found it straight after I posted. ........
  2. XLT1200 standard high/low mixture settings please

    Hi everyone. I had found the standard settings for the mixture screws for my 2004 XLT1200 on here but I've lost the post. I've been looking for over an hour, I think Ryejetski may have requested...
  3. Replies
    3
    Views
    5,879

    Thanks gossie. That was going to be my next...

    Thanks gossie. That was going to be my next question actually!
  4. Replies
    3
    Views
    5,879

    XLT1200 engine rebuild 2004

    Hi everyone. I'm about to start putting my engine together (fully rebuilt from crankshaft up). I will be converting to pre mix as well. Does anyone have any tips or tricks as I go for this model or...
  5. Replies
    4
    Views
    4,713

    Thanks Craig I will certainly check it out.

    Thanks Craig I will certainly check it out.
  6. Replies
    4
    Views
    4,713

    Thanks Rye. Mine actually isn't as bad as the...

    Thanks Rye.
    Mine actually isn't as bad as the one pictured, I wasn't able to take a picture of mine at the time. Every 2nd hand head I have looked at has one cylinder chamber with similar damage....
  7. Replies
    4
    Views
    4,713

    XLT1200 cylinder head damage

    Can anyone tell me if the damage done to a cylinder head in the picture is repairable or can be used again? Hopefully the image has attached, it is the usual exploded piston damage that a lot of...
  8. Replies
    0
    Views
    3,910

    Newbie with 2004 XLT1200 Waverunner

    Gday everyone. I've just gotten back into PWC after 15 years, and have recently acquired a 2004 1200 Waverunner. I'm rebuilding the engine with my son. We have done a lot of bikes, but would like to...
  9. Replies
    0
    Views
    4,130

    D plate required for Oz model XLT1200?

    Hi again. Did the OZ model actually come fitted with a cat converter? Or just the sensor? Either way is D plate and resistor recommend?
    Cheers,
    benny
  10. Yamaha Waverunner parts manual Oz model classification.

    Hi all. Can anyone tell me with regards to the Yamaha GP/XLT1200 parts manual, what country code the Australian models come under? The listings in USA, Japan, Canada and General.
    Cheers,
    Benny.
  11. Replies
    2
    Views
    5,133

    Thanks mate. Can you recommend a good Yamaha...

    Thanks mate. Can you recommend a good Yamaha dealer?
  12. Replies
    2
    Views
    5,133

    Xlt1200 - sleeves or nikasil cylinder

    Hi everyone. I'm rebuilding my 2004 XLT 1200 Waverunner and when I pulled it down I found it had 2 Nikasil cylinders and one sleeve type cylinder. My question is, given the price difference, would it...
Results 1 to 12 of 12
Back to top